S&B Filters Particle Separator 76-2001
30 days returnmoney back
The S&B Particle Separator removes 94% of dust from the airflow before it reaches your air filter, allowing your filter to last over 15 times longer before reaching capacity. A UTV’s filter can clog quickly, robbing the engine of power. The S&B Particle Separator is a game changer, allowing UTV owners to maintain horsepower and torque by keeping their air filters cleaner for a much longer period of time. S&B designed this system large enough so that there is no loss in power when used with the factory filter system. With the S&B Particle Separator, one (1) air filter will last as long as 15 would without the S&B system.* The S&B Particle Separator pays for itself and even saves you money because you will buy fewer filters. Billet clamps attach to your RZR's rear upper or lower roll bars. Accommodates virtually any roof & roll bar configuration.
2015-2016 Polaris RZR 900
Easy Install with detailed instructions
Dramatically extend the life of your filter
Maintain horsepower and torque longer
Save you money over constantly changing filters
30-day money-back guarantee
Free Shipping in U.S.
2015 Polaris RZR 900
2016 Polaris RZR 900
S&B air filters and intake kits purchased from Authorized Dealers are backed by S&B’s Million Mile Limited Warranty when used under typical driving conditions and on vehicles for which they were designed. If one of our products is not performing properly or is defective, S&B will replace it.
What is not covered by the S&B Warranty.
If you use an S&B product for (1) any type of racing or competitive event (2) any off-road use, (3) custom or modified product, (4) any industrial or marine applications, and/or (5) any illegal highway use. If an S&B product is not covered by our million mile warranty, our products are still warranted against manufacturing defects for one year from the date of purchase.
Warranty for Intake Elbows.
The warranty period for S&B Intake Elbows is 5-Years. Returns are not accepted once the parts have been installed. S&B DOES NOT RECOMMEND NOR DOES THE WARRANTY COVER CONDITIONS WHERE THE INTAKE ELBOW IS EXPOSED TO INTERNAL PRESSURE IN EXCESS OF 75 POUNDS PER SQUARE INCH (PSI). Visit www.sbfilters.com for actual burst test results. Exposing the Intake Elbow to pressures in excess of 75 PSI could cause the Intake Elbow to leak and/or rupture causing severe damage to your vehicle and/or serious bodily harm including death. Never run more than 5 PSI of pressure through the Intake Elbow with your hood raised. Special care should be taken when running a vehicle on a dyno to protect all personnel from flying debris in the event of a rupture of the part.
Warranty for Competitor Filters (AFE, Banks, K&N, etc.)
S&B warrants that filters made for our competitor’s intake kits will meet or exceed the claims made on the specific product page for the filter which was purchased. The S&B Engine Protection Limited Warranty does NOT apply for this category of filters (part #s starting with CR-) as S&B can’t be held accountable for a customer’s engine damage as this damage could have occurred with the original filter installed and thus prior to using the S&B filter.
Replacement of Product.
In order to return any product to S&B, an RMA number must be issued. Customer must supply proof of purchase and product must be sent back at customer’s cost.
Extent of Warranty.
If a defective product is properly returned to S&B, it will be replaced. S&B reserves the right to decide as to if the terms of the warranty outlined above have been followed properly. Should S&B decide that the terms of the warranty do not apply, S&B will under no obligation to honor this warranty. Under no condition shall S&B be responsible for any contingent, special, consequential, indirect or other damages.