aFe Power Silver Bullet Throttle Body Spacer 46-34014
30 days returnmoney back
The Serrated/Helix design creates air turbulence in the intake manifold. This turbulence increases the air pressure in the combustion chamber resulting in increased horsepower, torque, and improved throttle response. The Serrated/Helix combination design also reduces intake whistle that occurs with other helices only designs.
6061-T6 Billet Aluminum Construction:
All Silver Bullet Throttle Body Spacers are precision machined from 6061-T6 billet aluminum for lightweight, high strength and perfect fit and finish.
Installation Is A Snap:
This Silver Bullet throttle body spacer uses all factory mounting locations and a gasket providing stability and a hassle-free installation.
This throttle body spacer is not CARB exempt at this time and is not legal for sale in California or use on vehicles registered with the California Department of Motor Vehicles.
Will work with aFe's Momentum GT intakes (P/N: 51/54-74107).
+4 HP / +4 lbs. x Ft. Torque max gains
Throttle Body Spacer is a Serrated/Helix Combination Design for optimum airflow into the combustion chamber, precision machined from 6061-T6 aluminum
Installation is a Snap
30-day money-back guarantee
Free Shipping in U.S.
2015 Chevrolet Colorado 2.5L L4 | GMC Canyon 2.5L L4
2016 Chevrolet Colorado 2.5L L4 | GMC Canyon 2.5L L4
2017 Chevrolet Colorado 2.5L L4 | GMC Canyon 2.5L L4
2 Years Warranty
All warranty is limited only to the repair and/or replacement of the aFe product. Under no circumstances will the obligation or liability of aFe exceed the purchase price of the product as indicated on the original bill of sale. aFe excludes and disclaims any liability or obligation for incidental or consequential damages and cost related to such damages including but not limited to installation, removal or repair labor, rental vehicles, tow or any other inconvenience costs. Such costs will be the responsibility of the vehicle owner. aFe does not warranty any open box, used or items purchased from third-party eBay sellers.
• Turbochargers that have been opened or modified• Any products that have been cut, welded, or modified
• Any Scorcher Electronics that have been installed and non-defective
If you are going to return any product back to aFe, you must first receive an RGA (Returns Good Authorization) number and write that number on the box you are returning, along with a copy of the RGA sent to you. All shipments being returned to aFe must be shipped prepaid by the customer. If you are requesting a replacement part, you must first receive an RGA and aFe must receive the item for inspection. After review of the product returned and approval by our returns department, aFe will then send a replacement item. aFe will not send any replacement part before receiving the warranty return.
No other warranty expressed or implied applies nor is any person or advanced FLOW engineering authorized to assume any other warranty. Some States do not allow the exclusion or limitation of incidental or consequential damages or do not allow limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from State to State.